Most people who are at the point of having radon testing done on their home or business do not know what it going to happen if radon is discovered on the land. Many people believe that the discovery of radon means that a property is going to have to be abandoned and the value of the area is going to be lost. There are in fact, very few cases where the level of radon contamination was so great that the area had to be completely abandoned. Generally, radon detection is followed by a simple process of radon mitigation. Here are some of the things that might happen during radon mitigation.

The most often applied method of making a radon contaminated area safe is by radon removal. Radon removal involves the removal of the entire area of radon contamination. Since radon is often found in small pockets below the ground, removal or radon can likely as not be done by digging into the earth and taking out the contaminated material. This process is usually not overly invasive as it is not very likely that the radon contaminated area will be directly below your house, but rather someplace in the general area of your property. However, in cases where radon contamination is found directly below your home or the area where your building has been constructed, there are other options. In some instances, a hole can be dug to the same depth as the radon contamination and then another tunnel can be made over to the area which needs to be removed. The toxic material can then be brought out with minimal damage to the structure of your property.

Another typical type of radon contamination occurs through the water system. This problem is especially dangerous to people who use natural water sources, which are channeled in and out of their house through deep underground pipes. In these cases of radon water contamination, the radon might be difficult to remove from the water supply and thus the original water supply must be abandoned. The old water tanks and pipes might be fortified in order to ensure that no radon contaminated water can leak into the ground in the future and another water supply is brought in. If the area that is causing the contamination to the water supply can be isolated, then another water system can be installed in a safe are where the radon will not reach it.

The air is also a typical route though which radon contamination reaches a place of habitation. In the case of radon gas, many times an air filtration or an additional air ventilation system might be installed to redirect the contaminated air from the ground. Often times a radon gas leak is the hardest to remove because it might be present in large areas of the property and in these cases the air ventilations systems are highly effective in minimizing the potential exposure to people in the area. Go and check out www.mtn-inc to find out about all the different ways companies can eliminate environmental contamination from a property.

Uncategorized |

Comments are closed.